COBI F-117 Nighthawk Set #5903: Stealth Jet Build Guide
By COBI Bricks: Building Blocks For Kids, Construction Block | Published: 2026-11-03
Category: 操作指南
Build COBI's 1:48 F-117 Nighthawk with a clear step order, beginner-friendly tips, and display advice for the stealth fighter brick model.
Quick answer
Start with the cockpit and nose, then build the fuselage in sections before attaching the wings and tail. Sorting the dark tiles and angled plates first makes the COBI F-117 Nighthawk build smoother and helps you avoid rework on the stealth surfaces.
Why the F-117 build rewards a slow start
The F-117's shape depends on flat, angled surfaces that meet cleanly. Rushing the first bags often leads to misaligned plates that are hard to spot until the wings go on, so plan to spend extra time on the nose and cockpit area before moving to the main body.
Beginner-friendly approach to a stealth jet model
If this is your first COBI jet, work on a large, well-lit tray and keep sub-assemblies together. The dark color scheme makes small parts easy to lose, and the 1:48 scale means detail parts are small but manageable when you build in short sessions.
Step-by-step F-117 Nighthawk build
- Sort parts by bag and color: Open only the bags for the first build stage and group dark tiles, angled plates, and small greebles into separate piles. Common mistake: mixing all bags at once, which makes black and dark gray pieces hard to distinguish. Keep the instruction manual flat and use a small dish for tiny parts.
- Build the cockpit and nose first: Assemble the cockpit tub and nose section exactly as shown, pressing plates fully down. Checkpoint: the nose should be symmetrical and sit flat on the table before you attach it to anything else. Test-fit the canopy frame without forcing it; if it rocks, a plate is not seated.
- Assemble the fuselage in sub-sections: Build the central fuselage in the manual's order, then join the nose and tail sections. Common mistake: attaching wings before the fuselage is fully pressed together, which can leave gaps along the spine. Run a finger along each seam after every few steps to catch loose plates early.
- Attach wings and tail surfaces last: Mount the wings and tail only after the fuselage is stable. Check that the wing angle matches the manual's diagrams; the F-117's faceted shape makes small misalignments obvious from above. Set the model on a flat surface and sight along the wings before adding final details.
- Add detail parts and check stability: Install remaining tiles, sensors, and landing gear or display elements. Common mistake: handling the model by the wings during this stage, which can pop off angled plates. Lift the finished model from the fuselage center, not the wingtips.
Product facts
- COBI F-117 Nighthawk Stealth Fighter: Set #5903: 1:48 scale model of the F-117 Nighthawk stealth aircraft. The scale gives you a display-friendly size that still shows the jet's distinctive faceted shape.
COBI F-117 Nighthawk Stealth Fighter: Set #5903
